I went in minicom and did the port for /dev/ttyS1 but I don't think that's the USB modem.

I think that's because all the things I have done to get this USB modem to work. I could only say yes or no and I said yes and it booted up then. Then it said something like change the network. It did not come back on a reboot till I hooked a screen to it. I rebooted my Ubuntu server because I did so many things to get the USB modem to work. You do not need to install any drivers off the USRobotics installation CD-ROM.Ĭan any one tell me what to do by what this quoted text says? Installation of the modem under these kernels is fully automatic provided your kernel has the Plug and Play module enabled (default). You need a USB modem driver (CDC ACM) compiled into a Linux kernel 2.4.20 or higher or as a loadable module for your kernel. What /dev would this be on? Or do I need to install some driver? lsmod command shows this cdc_acm in it like this: When I do a modprobe cdc_acm command it looks like it does nothing.

Predictive diagnostics for card in bus 001: (Lucent) I know because if I unplug the it from the USB and do lsusb again it's not there. (Lucent)īus 001 Device 003: ID 0557:2008 ATEN International Co., Ltd UC-232A Serial Port Here are some commands I lsusbīus 001 Device 004: ID 047e:2892 Agere Systems, Inc. I can never get the green power LED to go on it. It's small so I can just use it on a USB port. So I got a USRobotics USR5637 56K V.92 USB modem. I have Ubuntu server installed on a small Mini-ITX.

Install cdc acm driver linux